STM32f030K6T6 定时器3配置方法及频率计算公式

频率计算公式为，使用48M晶振：48000000/48/100=10000HZ

可得：频率为10K HZ

中断时间为：1/10000=100us

void TIM3_Init(void)//0.1ms
{

	TIM_TimeBaseInitTypeDef          TIM_TimeBaseInitStructure;
	NVIC_InitTypeDef                NVIC_InitStructure;

	RCC_APB1PeriphClockCmd(RCC_APB1Periph_TIM3, ENABLE);  //tim3时钟使能,APB时钟48M

	TIM_TimeBaseInitStructure.TIM_ClockDivision = TIM_CKD_DIV1; //分频系数为1
	TIM_TimeBaseInitStructure.TIM_CounterMode = TIM_CounterMode_Up; //向上计数
	TIM_TimeBaseInitStructure.TIM_Period = 100 - 1;
	TIM_TimeBaseInitStructure.TIM_Prescaler = 48 - 1; //定时100us
	TIM_TimeBaseInit(TIM3, &TIM_TimeBaseInitStructure);
    TIM_SelectOutputTrigger(TIM3, TIM_TRGOSource_Update);

	TIM_ClearITPendingBit(TIM3, TIM_IT_Update);
	TIM_ITConfig(TIM3, TIM_IT_Update, ENABLE); //允许定时器3更新中断
	
    

	NVIC_InitStructure.NVIC_IRQChannel = TIM3_IRQn; //定时器3中断
	NVIC_InitStructure.NVIC_IRQChannelPriority = 0; //优先级0
	NVIC_InitStructure.NVIC_IRQChannelCmd = ENABLE;
	NVIC_Init(&NVIC_InitStructure);
    TIM_Cmd(TIM3, ENABLE); //使能定时器3
}
void TIM3_IRQHandler(void)//100us
{
	if(TIM_GetITStatus(TIM3, TIM_IT_Update) != RESET) //溢出中断
	{
		cnt10ms++;
		cnt20ms++;
        cnt1ms++;
        cnt1s++;

		TIM_ClearITPendingBit(TIM3, TIM_IT_Update); //清除中断标志位
	}

}