HDLBits刷题_Verilog Language_Module fadd

学习内容
In this exercise, you will create a circuit with two levels of hierarchy. Your top_module will instantiate two copies of add16 (provided), each of which will instantiate 16 copies of add1 (which you must write). Thus, you must write two modules: top_module and add1.

Like module_add, you are given a module add16 that performs a 16-bit addition. You must instantiate two of them to create a 32-bit adder. One add16 module computes the lower 16 bits of the addition result, while the second add16 module computes the upper 16 bits of the result. Your 32-bit adder does not need to handle carry-in (assume 0) or carry-out (ignored).

Connect the add16 modules together as shown in the diagram below. The provided module add16 has the following declaration:

module add16 ( input[15:0] a, input[15:0] b, input cin, output[15:0] sum, output cout );

Within each add16, 16 full adders (module add1, not provided) are instantiated to actually perform the addition. You must write the full adder module that has the following declaration:

module add1 ( input a, input b, input cin, output sum, output cout );

Recall that a full adder computes the sum and carry-out of a+b+cin.

In summary, there are three modules in this design:

top_module — Your top-level module that contains two of…
add16, provided — A 16-bit adder module that is composed of 16 of…
add1 — A 1-bit full adder module.

If your submission is missing a module add1, you will get an error message that says Error (12006): Node instance “user_fadd[0].a1” instantiates undefined entity “add1”.

module top_module (
    input [31:0] a,
    input [31:0] b,
    output [31:0] sum
);//
    wire [15:0]sum1,sum2;
    wire cout;
	add16 add16_1( 
        .a(a[15:0]), 
        .b(b[15:0]),
        .cin(0), 
        .sum(sum1), 
        .cout(cout) 
    );
	add16 add16_2( 
        .a(a[31:16]), 
        .b(b[31:16]),
        .cin(cout), 
        .sum(sum2), 
        .cout() 
    );  
    assign sum = {sum2,sum1};
    
endmodule

module add1 ( input a, input b, input cin,   output sum, output cout );

// Full adder module here
    assign {cout , sum} = a + b + cin;
endmodule