HDLBits 系列（39）求解带有奇校验的串口接收数据的简化电路设计

目录

求助原题

我的方案

状态转移图

我的设计

等待你的方案？

---

求助原题

先给出原题：（蓝色字体，即是链接本身）

We want to add parity checking to the serial receiver. Parity checking adds one extra bit after each data byte. We will use odd parity, where the number of 1s in the 9 bits received must be odd. For example, 101001011 satisfies odd parity (there are 5 1s), but 001001011 does not.

Change your FSM and datapath to perform odd parity checking. Assert the done signal only if a byte is correctly received and its parity check passes. Like the serial receiver FSM, this FSM needs to identify the start bit, wait for all 9 (data and parity) bits, then verify that the stop bit was correct. If the stop bit does not appear when expected, the FSM must wait until it finds a stop bit before attempting to receive the next byte.

You are provided with the following module that can be used to calculate the parity of the input stream (It's a TFF with reset). The intended use is that it should be given the input bit stream, and reset at appropriate times so it counts the number of 1 bits in each byte.

module parity (
    input clk,
    input reset,
    input in,
    output odd);

    always @(posedge clk)
        if (reset) odd <= 0;
        else if (in) odd <= ~odd;

endmodule

Note that the serial protocol sends the least significant bit first, and the parity bit after the 8 data bits.