CDAC-SW 驱动mos m=32时,报错:
Error found by spectre during IC analysis, during transient analysis tran'. ERROR (SPECTRE-16385): There were 7 attempts to find the DC solution. In some of those attempts, a signal exceeded the blowup limit of its quantity. The last signal that failed is I(V14:p) = 1.80144 GA, for which the quantity is
I’ and the blowup limit is (1 GA). It is possible that the circuit has no DC solution. If you really want signals this large, set the `blowup’ parameter of this quantity to a larger value.
ERROR (SPECTRE-16080): No DC solution found (no convergence).
这个器件是总电源VSSA。
带隙基准接入开关电路后,产生振荡
红色为CLK3 , 开关信号
使用理想运放没有问题,但使用实际二阶运放就有问题了,这个手搭的运放增益为100dB,很大了
另外,前面运放70dB左右时,振荡更厉害,密密麻麻。增加增益还是有用的。
为什么振荡?
估计是反馈产生的问题
接个电容可否?把交流放电掉
测了10ms,绿线是BGR输出。ok了。
接个3pF电容,可以了,(1,2pF还是会振荡,只不过振荡时间延后了,且变成了上面提到过的密集振荡,这个不知道为什么,先不分析了)
接入后级电路后,又振荡了。。
加电容到7pF,ok,不振荡了。