RNG 的操作方式

最新推荐文章于 2024-08-20 21:45:29 发布

Thisliver

最新推荐文章于 2024-08-20 21:45:29 发布

阅读量1.3k

点赞数

分类专栏： STM32-RNG 文章标签： RNG stm32

本文链接：https://blog.csdn.net/thisliver/article/details/78894578

版权

STM32-RNG 专栏收录该内容

1 篇文章 0 订阅

订阅专栏

Operation of RNG

To run the RNG, follow the steps below:

1. Enable the interrupt if needed (to do so, set the IE bit in the RNG_CR register). An interrupt is generated when a random number is ready or when an error occurs.

2. Enable the random number generation by setting the RNGEN bit in the RNG_CR register. This activates the analog part, the RNG_LFSR and the error detector.

3. At each interrupt, check that no error occurred (the SEIS and CEIS bits should be ‘0’ in the RNG_SR register) and that a random number is ready (the DRDY bit is ‘1’ in the RNG_SR register). The contents of the RNG_DR register can then be read.

NOTE: A generated number required to compare with the previous one, it fails if turns out to be equal.