STM32 小坑笔记

开启pwm不能使用ALL　

    HAL_TIM_PWM_Start(&htimx, TIM_CHANNEL_ALL);　// 无法实现

/**
  * @brief  Starts the PWM signal generation.
  * @param  htim TIM handle
  * @param  Channel TIM Channels to be enabled
  *          This parameter can be one of the following values:
  *            @arg TIM_CHANNEL_1: TIM Channel 1 selected
  *            @arg TIM_CHANNEL_2: TIM Channel 2 selected
  *            @arg TIM_CHANNEL_3: TIM Channel 3 selected
  *            @arg TIM_CHANNEL_4: TIM Channel 4 selected
  * @retval HAL status
  */
HAL_StatusTypeDef HAL_TIM_PWM_Start(TIM_HandleTypeDef *htim, uint32_t Channel){
  uint32_t tmpsmcr;

  assert_param(IS_TIM_CCX_INSTANCE(htim->Instance, Channel));

  if (TIM_CHANNEL_STATE_GET(htim, Channel) != HAL_TIM_CHANNEL_STATE_READY) {
    return HAL_ERROR;
  }
  TIM_CHANNEL_STATE_SET(htim, Channel, HAL_TIM_CHANNEL_STATE_BUSY);

  TIM_CCxChannelCmd(htim->Instance, Channel, TIM_CCx_ENABLE);

  if (IS_TIM_BREAK_INSTANCE(htim->Instance) != RESET) {
    __HAL_TIM_MOE_ENABLE(htim);
  }

  if (IS_TIM_SLAVE_INSTANCE(htim->Instance)) {
    tmpsmcr = htim->Instance->SMCR & TIM_SMCR_SMS;
    if (!IS_TIM_SLAVEMODE_TRIGGER_ENABLED(tmpsmcr))　{
      __HAL_TIM_ENABLE(htim);
    }
  } else {
    __HAL_TIM_ENABLE(htim);
  }
  return HAL_OK;
}