ecoRoute

最新推荐文章于 2025-03-11 08:00:00 发布

每天一个小脚印

最新推荐文章于 2025-03-11 08:00:00 发布

阅读量2.3k

点赞数 1

分类专栏： # + 后端Tool工具使用(Innovus) EDA

本文链接：https://blog.csdn.net/hepiaopiao_wemedia/article/details/105338476

版权

+ 后端Tool工具使用(Innovus) 同时被 2 个专栏收录

14 篇文章

订阅专栏

EDA

6 篇文章

订阅专栏

本文深入解析了基于Nanometer路由器的ECO路由命令的使用方法及参数，包括修复DRC违规、处理分区设计、指定层修改等特性。介绍了如何通过启用特定选项来优化设计，提升路由效率并改善定时。

摘要生成于 C知道，由 DeepSeek-R1 满血版支持，前往体验 >

This command is based on the Nanometer router.

You must first run ecoDefIn and ecoPlace before you use this command.

-cut_color_flip {0 1}: Fixes cut color DRC violations by flipping. When enabled 1, the ecoRoute command fixes the cut same-mask spacing violations by flipping the color of the cut.

-fix_drc: Fixes violations on existing RDC markers in the design. When enabled, it allows NanoRoute to fix only the DRC's on existing DRC markers in the design. If violations increase then the ecoRoute command reverts to the original shot of the design.

-handlePartition: For the nets in bierarchical parition design, the ECO routing performed is partition aware with this option.

-modifyOnlyLayers <bottomLayer:topLayer> Default: ECO routing can occure on any layer and any nets: Enable the NanoRoute router to remove sements of net routing in the specified layer range, from bottomLayer to topLayer.

-prototype: Enables prototyping while doing ECO routing. When specified, it enables NanoRoute to work on the nets selected to route and stop early before DRC cleanup to provide a quick snapshot for the designer. This mode is intended to help the designer know if the routing is possible and if the ECO can improve timing.

-target: Enables NanoRoute to work on the nets selected to route. In this mode, the router ignores the already existing DRC violation markers that are not on the ECO nets or are on nets selected to route.

-trim_layer_patch: Enables the ecoRoute command to only add trim and patch metals in a given area.