PM803F 3BDH000530R1状态与新插入的SM811一致

应配置模块以便进行同步。当运行SIL3应用程序时，用户必须接受同步的开始，以配置插入的模块。如果一个或多个SIL3应用程序在控制器中运行，则它们被临时中断，以便使应用程序的状态与新插入的SM811一致。用户必须通过在已经运行的主安全模块上的数字输入3上创建边缘来确认应用程序停止。

这是通过将物理按钮连接到数字输入来执行的。系统等待确认30分钟，如果未接收到确认，则插入的SM811将关闭。为了恢复，需要启动新的热插拔，即SM811必须被移除并再次插入。SM811的同步包括：

1.确保SM811之间的同步链路已就位，也就是说，封闭的TK852V010电缆已分别正确连接到两个SM链路连接器中。

2.将SM811插入其位置。

3.当SM811启动时，同步LED闪烁，随后它继续闪烁，并按顺序闪烁3次和暂停。

4.按下按钮（在已经运行的安全模块上的数字输入3上创建一个边缘），一旦它开始以3次闪烁和一个暂停序列重复闪烁。

5.同步指示灯闪烁得更快，直到同步完成。6.模块同步时，同步指示灯变为黄色。

非SIL和SIL1-2应用程序不受SM811同步的影响。它们在整个同步过程中继续正常执行，不会被中断。SM811的热插拔要求两个安全模块通过同步链路连接，用于传输应用程序状态。在热插拔过程中，无法从Control Builder下载新配置，控制器是保留的。Control Builder用户会收到一个信息对话框的通知。热插入结束或中止时，将释放保留。如果正在进行配置下载，则在下载完成后开始热插入。

The reliability measures in decentralized control systems adopt many technical measures to improve reliability. These technical measures are based on the following four basic ideas: firstly, to make the system itself less prone to faults, which is called fault prevention; The second is to minimize the impact of system failures as much as possible, namely the so-called fault security and fault weakening; The third is to be able to allow the system to continue operating when a fault occurs, which is known as fault tolerance; The fourth is that when a system malfunctions, maintenance can be carried out without stopping the system operation, which is called online maintenance. Based on these four basic ideas, various reliability measures have been adopted in distributed control systems.

Strict quality management and improvement of system hardware level are the material foundation for the normal operation of the system, and are also the key factors affecting system reliability. Therefore, increasing the average time between failures (MTBF) of hardware is an important measure to improve system reliability.