本文介绍了数字后端中的屏蔽路由技术，通过Innovus的NanoRoute路由器进行屏蔽，以减少串扰。内容涵盖使用createShield命令创建屏蔽网络，编辑功率过孔以增强连接，通过GUI和文本命令添加屏蔽路由，以及如何控制屏蔽报告内容。同时，文中提及了tapping check的概念，讨论了未被屏蔽的信号段和浮动的屏蔽网络段。
文章目录
在数字后端设计中使用shielding的目的主要是保护敏感net，减小其受到noise的影响。常用的shielding net是VDD和GND net。
查看Innovus UG > Design Implementation Capabilities > Using the NanoRoute Router
Performing Shielded Routing
The NanoRoute router can protect noise-sensitive nets, such as clock nets, from crosstalk by shielding them with power or ground wires. NanoRoute automatically generates a shielding and statistics report after routing. For information on the report, see the “Interpreting the Shielding Report” section.
The Figure below shows a section of a design with a shielded net. In the figure, you can see the following:
- The signal net is shielded by a power net on one side and a ground net on the other side. （两条shielding net分别是VDD和GND）
- Multiple vias can be dropped where a stripe crosses the shielding net at a right ang
最低0.47元/天 解锁文章
扫一扫
1795
被折叠的 条评论
为什么被折叠?
到【灌水乐园】发言
